![]() ![]() In the Install Printer Software box, click Have Disk, then select Browse.With Generic Network Card selected, click Next, then click Finish.Type the IP Address from the printer that you obtained from the "Recording the Printer IP Address" procedure above (make sure that the IP Address is static on the printer itself), then click Next.For "Type of port" select Standard TCP/IP Port, then click Next.Select Local printer attached to this computer, then click Next.Double-click Add Printer, then click Next. ![]() WINDOWS 7: Select Start > Devices and Printers.WINDOWS XP or VISTA: Select Start > Control Panel > Printers and Faxes.Do one of the following depending on your operating system:.Enter the IP Address that you recorded in Step 3, then press OK.Press OK and select Manual (Static), then press OK.Scroll down and select Advanced IP Address Setup, then press OK.Scroll down and record the IP Address: #.#.#.#.Select View Network Configuration, then press OK.Scroll down and select Network Settings, then press OK. Setting up a Manual IP Address Connection NOTE: If scanning is not possible, connect your printer with a USB cable to enable scanning. Do the procedure below to set up a Manual IP Address Connection that will enable printing and possibly enable scanning.Add a wireless access point to your network that is compatible with your printer and your ACTIONTEC Router.NOTE: The ACTIONTEC Router is one of a few routers that is not currently compatible with your printer. Use a router that is compatible with your all-in-one printer.Connect your printer to your computer using a USB cable.If your printer can't communicate with your ACTIONTEC Router, the following options may help you work around the issue: Contact your router supplier for the latest information regarding multicast support, and make sure you update the firmware to the latest version available for your router. Kodak is working with Actiontec to make these routers compatible with wireless-enabled printers. Modified on: Thu, 20 Aug, 2020 at 2:21 PMĪCTIONTEC Routers may not support the multicast protocol, which your network must have to detect your printer. Solution home Kodak Legacy Product FAQs Inkjet Printers Why can't the printer software detect my all-in-one printer that is connected to my wireless network using an ACTIONTEC (Qwest) M1000, PK5000, GT724WG, GT701WG ADSL, or MI424WR router? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |